No hay artículos en el carro
No hay artículos en el carroDescripción del producto
Extractor de engranajes de piñón
herramienta extractor de piñón
Paso #1
Elige el pin adecuado e insértalo en la barra giratoria. Bloquea el pasador, utilizando la llave hexagonal proporcionada.
Paso #2
Gira la varilla en el soporte.
Paso #3
Monta la placa deslizante haciendo coincidir su garganta con el eje del motor.
(Gargantas de diferentes grosores están disponibles. Elige la garganta adecuada)
Paso #4
Asegúrate de que el eje del motor se encuentre verticalmente con la cabeza del pasador. Consigue la barra giratoria a través de la barra y luego gírala en el sentido de las agujas del reloj hasta que tire del engranaje del piñón.
Charlie
Comentado en los Estados Unidos el 27 de marzo de 2025
Works but has a learning curve to operate and some motors have very small gaps so it's hard to find leverage on some motors.
Jace
Comentado en los Estados Unidos el 6 de febrero de 2025
Literally just broke all the pieces that would even fit the gear. The metal is so weak it just folds after the first resistance. Absolutely garbage don’t waste your time unless the motor is all plastic and press fit on maybe.
Dave M.
Comentado en Canadá el 14 de febrero de 2025
Very crudely made. The one sent to me was missing the base plate, so I did not get a chance to try it. I returned it.
Bill M
Comentado en los Estados Unidos el 15 de octubre de 2024
I used the puller to remove the pinion gear from a small, 130 size motor from an RC tank. I had tried heating the gear and prying it off with no success. I am sure I would have destroyed the motor and gear if I continued. With the puller, the gear came of using only finger pressure on the screw, very easy to set up and use, no damage to my equipment. No bending of the push pin. I did measure the motor shaft, so I could select the thickest pin that would not get stuck in the gear. I am sure I will use this again. I would buy this again.My first impression upon unpacking was that the unit was tiny, I didn't know they made gear pullers this small. There are no instructions included, this may be a blessing considering some instructions I have read.
Patrick V.
Comentado en los Estados Unidos el 30 de mayo de 2023
Would not fit to pull a 22t pinion from a 550 motor. It would probably work for something smaller. Returned for a refund.
Productos recomendados
Mex $2,939.31
Mex $ 1,410 .00 Mex $1,410.00
Mex $357.23
Mex $ 189 .00 Mex $189.00
Mex $6,160.64
Mex $ 1,881 .00 Mex $1,881.00