No hay artículos en el carro
No hay artículos en el carro Características del artículo:
* Se envía en caja.
* Hecho de material de grado OE PA6+GF30 para asegurar hasta 50000 veces de uso.
* Añade anillo de sellado para cumplir con la tasa de impermeabilidad IPX7.
* Utilice un motor de alto flujo y presión para garantizar el rendimiento del equipo original.
* El artículo fue montado por máquina automática y probado bajo el estándar OE para garantizar un ajuste perfecto.
scott schmittinger
Comentado en los Estados Unidos el 12 de enero de 2025
repaired 07 Bmw 328i leaking wiper reservoir. Extremely easy repair. Remove passenger side front tire, remove inner fender liner (8mm). unbolt reservoir tank (10mm). Slide tank out. Replace pump and grommet, both included in this kit. Reinstall, opposite order.
Customer
Comentado en los Estados Unidos el 27 de mayo de 2024
Product worked as described, install is rough but doable (2 hours). Had to remove the passenger side front tire and inner fender liner. There are good YouTube videos to guide you through the install, hoping this product lasts a while because I do not want to do this install again.
Mieke Seells
Comentado en los Estados Unidos el 5 de septiembre de 2024
Worked initially. Stopped working after 9 months. Has corrosion around the body of it. Looks like it developed a crack. Three thumbs down
The Captain
Comentado en los Estados Unidos el 28 de abril de 2023
Strange that Amazon wants you to rate the ease of install or longevity as install is a PITA (not products fault) and how would I know longevity? Anyhoo, I installed in a 2010 328xi. It will take you awhile as you have to remove most of the wheel well liner to get the reservoir out. Pro tips: you should buy some of the plastic rivets for the liner because you lose the center pin when you remove them. You should also have a way to remove the fluid or the reservoir will be heavy and much harder to maneuver. Once the old one was out, putting the new one in wasn't easy as it goes about halfway and then seems like it won't budge. I used a clamp and it snapped into place. The bushing was a nice tight fit in mine. Once completed, test it before you button it up. On mine the passengers worked but the driver's side clogged almost immediately, the nozzle filters were clogged with a kind of light colored silt. I had to remove the washer nozzles and clean the filter as well as blow backwards through the tubing to clear the filters inside the reservoir. It clogged once more on the driver's side, and I repeated that and all has been good since. Worth the time, and thankful the part wasn't any more $$. I wish I could tell you if the pump changed the strength of the stream. It's at least the same if not stronger, and definitely strong enough.
peter
Comentado en los Estados Unidos el 1 de noviembre de 2022
Good product lets see in 6 months
Productos recomendados